sheet width 3100 mm
plate thickness 14.0 mm ST
pre-bending 12.0 mm ST
diameter of upper rolls ~ 290 mm
side roll diameter ~ 210 mm
diameter of lower rolls ~ 270 mm
bending speed ca. 2.0 + 5.0 m/min
Control ELAP LYNX
oil volume 125 Liter
voltage 380 V
total power requirement 11.0 kW
weight 9000 kg
range L-W-H 4800 x 1900 x 1600 mm
** Very good condition (!!)
** Current new price including accessories approx. 110.000 Euro
** Special price upon request

Equipment:
- Robust electro-hydraulic 4-roll bending machine
* ??4-roll concept offers a wide range of bending and rounding options
- MG NC control unit "ELAP LYNX"
* Operation - Control of all rolls and machine axes
* Digital position display
* Manual operation via joysticks
* Freely movable control panel
- Two central rolls are directly driven by hydraulic motors
- Conical rolling is possible by tilting the rolls
- Parallelism of the side rolls via torsion shafts
- Pre-bending on both sides
- Diameters of up to 1.1 times the top roll diameter are possible
- Forged and hardened rolls with a hardness of 53-55 HRC
- Low-maintenance, robust machine design
- Permanent lubrication of all components Bearings
- Sturdy welded steel construction
- 2x bending speeds selectable
- Electro-hydraulic folding bearing for easy pipe removal
- Pressure gauge/pressure indicator for the rollers
- Safety device (safety lanyard with switch unit)
- Operating instructions (PDF)
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.