Conversion kit high-speed cutter rezervni deo za Wohlenberg štamparske opreme
PDF
Podeliti
Facebook
WhatsApp
Viber
Telegram
Zainteresovani ste za oglas?
1/6
PDF
Podeliti
Facebook
WhatsApp
Viber
Telegram
Cena:
na upit
Zatražite cenu
Kontaktirajte prodavca
Tip:
rezervni deo
Lokacija:
Nemačka Dabergotz6917 km od vas
Datum objavljivanja:
13. 10. 2024.
Machineryline ID:
ZU33120
Stanje
Stanje:
polovne
Važno
Ova ponuda је informativnog karaktera. Za više detalja, pitajte prodavca.
Saveti za kupovinu
Kontakti prodavca
Pretplatite se na prodavca
Torsten Kirchhof
Jezici:
nemački, engleski
Пон - Пет
09:00 - 18:00
+49 3391 4...
Prikaži
+49 3391 401570
+49 3391 40...
Prikaži
+49 3391 4015722
Adresa
Nemačka, Brandenburg, 16818 , Dabergotz, Bahnhofstrasse 13 a
Lokalno vreme prodavaca:
21:24 (CEST)
Pošalji poruku
Kontakti prodavca
3p Vertriebsgesellschaft mbH
Nemačka
2 godine na Machineryline
2.8
10 komentara
Pretplatite se na prodavca
+49 3391 4...
Prikaži
+49 3391 401570
+49 3391 40...
Prikaži
+49 3391 4015722
Pitajte prodavca
PDF
Podeliti
Facebook
WhatsApp
Viber
Telegram
Prodajete tehniku?
Učinite to sa nama!
The following steps are necessary for the conversion to LCD
1. disassemble monitor chassis
2. remove picture tube and circuit board (ventilate tube properly
dispose of)
3. function keys
alpha keyboard remains (if available)
4. new LCD chassis
loosen nuts and lift off frame
5. insert the chassis from the rear
attach the front frame and screw tight
6. pull off the AMP plug from the CPU
eject the contacts
7. set voltage at potentiometer to 12 volts
Press in new pins according to the enclosed pin assignment
9. pinch off the crimp contacts of system 86/90 and push them into the pin header
10.plug on AMP connector system 85 / pin header for system 86
11.for system 86/90
tap voltage at switching power supply (bypass terminals)
12.settings of the LCD monitor is done by three keys on the board